Published at Wednesday, February 27th, 2019 - 12:02:25 PM. Fence. By Musette Blot.
What is an underground dog fence? An underground dog fence is a system consisting of a radio transmitter, wire that acts as a transmitting antenna and a collar with a receiver that picks up the radio signal from the fence when your dog gets too close. When your dog enters the warning area near the wire the collar beeps warning him to stay back. If he continues to move toward the wire he will receive a static shock or correction. Some systems have progressive corrections so that the closer the dog progresses toward the wire the stronger the static shock he receives. There is some controversy about the humane aspect of delivering a shock to an animal to deter him. Most experts agree however that when an underground dog fence is properly installed and the dog is properly trained to the fence that these systems are very humane and safe. Consider the alternative if your dog runs out into traffic or gets lost. There is some chance of your dog being traumatized by the shock of he is improperly trained and/or the correction levels are too high for your particular dogs size and temperament. Proper training is critical to success with these systems. Yes, it is true that your dog, hopefully, will not like receiving the shock no more than you like touching a door knob and getting a static shock. This is his incentive to avoid the boundary. While the shock is uncomfortable it is not in itself dangerous to the animal. Most systems have automatic shut offs if the animal does not move out of the correction zone to protect him from over correction. Compared to a traditional fence an underground dog fence is fairly easy to install and should take less than a day with most applications. The hardest part of the installation is burying the wire. I offer four methods of burying the wire. The first is to use a straight edge spade shovel and use it to dig down about 3 inches and create a V-shaped trench to lay the wire in. The simply press the sod or dirt back in place. This is the most difficult and time consuming method. The second way is to use a gas powered lawn edger to cut a 3 inch deep trench. Lay the wire in the trench and replace the displaced dirt and press into place. The third method is to rent a trencher with a cable installation attachment. The trencher will cut the trench and lay the wire at the same time. The fourth method is to not bury the wire at all. Instead you can simple lay the wire above ground and use Pet Fence Staples to hold it in place. This method works well for low traffic areas and in grassy areas where the wire will lay deep in the turf. If you have to cross a driveway or sidewalk with the wire you will need to use a masonry blade to cut a groove in the concrete or asphalt and then use caulk to seal the wire into place. There are many factors involved in choosing the right underground dog fence system. Some of these factors are discussed below. Later on Ill make specific recommendations based on these factors. Wireless dog fences are not considered in this discussion.
Recommended Time Frame for Cleaning a Wood Fence: * For maximum results we recommend that you clean/re-stain your wood fence once every 3-5 years. Cleaning: IF you have a cedar fence, you may notice that it will begin to turn a grayish color or the paint/stain will begin to lose its brightness and regardless of what kind of wood fence you have, you may notice a mold begin to develop on the fence. This section of the article will explain how to take care of these problems and get your wood fence looking new again! If you decided to use plastic sheeting to protect your grass, you will want to lay that on the ground underneath the fence prior to starting any cleaning. (Using plastic sheeting will protect your grass from any harmful chemicals that may be in the cleaning solutions). A mixture of 1 part bleach and 2 parts water is very common when cleaning wood fences; however, you may also purchase wood cleaning solution from your local hardware store. What you will want to do first is apply the cleaning solution to the fence and allow it to soak in until you notice that the fence is becoming brighter and/or clean. You will then want to spray the fence off with a water hose (use a power washer for removing old paint or tough stains - make sure power washer is on the widest spray setting and held about 12 inches away from fence). After the fence has been cleaned and sprayed off you will want to allow it to air dry. If it still needs cleaning in certain spots after it dries, repeat the above mentioned process. Once the fence is clean and dry you are ready to apply a strain. (If you do not wish to stain a certain color, you can use a wood sealant to ensure that the fence will look new for a long time). NOTE: DO NOT USE PAINT ON YOUR WOOD FENCE, INSTEAD USE A STAIN. Properly apply the strain and allow the stain to dry. Your wood fence should now look beautiful and brand new. If you apply this process at least every 3 - 5 years, your wood fence will look beautiful and brand new for a long time!
Any content, trademark’s, or other material that might be found on the Proxifeed website that is not Proxifeed’s property remains the copyright of its respective owner/s. In no way does Proxifeed claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.