By Pruie Andre. Fence. Published at Tuesday, November 21st, 2017 - 18:54:32 PM.
Cleaning: If you want to give your children a chore to do around the house, now is the time. Cleaning a chain link, steel or aluminum fence is very easy and can be performed by almost anyone. Most of the time you can clean your metal fence by simply spraying it off with a water hose; however, if you come across some tough stains or areas that need a little scrubbing, the following advice should do the trick. First you will want to prepare a bucket of soapy water. To do this, simply fill a bucket with warm water and mix with any cleaning solution that will not increase chances of rust development. You will then want to take your soft bristle scrub brush and dip it in the soapy water. After the brush is wet, simply scrub the areas of the fence that need cleaning and rinse by spraying off with a water hose... Its that easy.
Battery cost Battery life will vary depending on things like how often your pet approaches the barrier. Over time battery replacements, especially for the proprietary batteries used in the PetSafe systems could become a bigger expense than going with a rechargeable system.
INSTALLATION- Do we have all our materials? OK lets go. Starting in one corner, dig your first post hole. Dont cheat. A shallow hole will weaken your fence and shorten its life span. A 12 wide hole is acceptable for fence posts. Now continue down one side of the fence line until all the holes are dug. If you are using a pair of hand post hole diggers, your arms are now worn out. If you are using a power post hole auger that you rented, it should make short work of this chore. Place your two end posts in their holes. Plumb them using your 4 level and install two temporary braces on each to hold them plumb. With this done Im going to save your some work here. Pour a bag of the bagged of concrete into each hole DRY. OH, OH. Where is the concrete? You didnt get it? Did you write it down? If you look back I didnt tell you to. OK. Go get the concrete, you need a break anyway. Seriously, it is a good habit to start to write down all the items you need before you go shopping. It saves a lot of time and extra trips. OK now with a dry bag of concrete in each hole; hook up your garden hose without a nozzle. Start placing water on top of the dry concrete and by using your shovel to prod the concrete in an up and down motion and pushing the hose in and out of the concrete it will mix right in the hole. Dont make it too wet. Somewhat soupy is fine but try not to separate the ingredients with too much water. There are several brands of redi-mix bagged concrete available and they will all work this way. You can now start on the holes for the 2nd side while the concrete dries for the first two posts. Perform the same function with the next corner post and the 4th post until all corner posts are set in concrete. Go back to your first two posts. Using your string line, tie it to the first post and run it to the next corner post and tie it off making it as taught as you can between the posts. MAKE SURE THE STRING IS TIGHT AGAINST THE SAME SIDE OF BOTH POSTS. If you use the inside or outside it doesnt matter as long as they are both the same. Now you can install the mid posts without a lot of measuring. By simply pacing the post against the string, you will have them all in the same line. Check carefully that your spacing is correct between posts. The posts may be off center of the holes but thats OK. With all the posts in on one side, pour them in concrete. Try not to leave holes open overnight both for protection against rain and children or animals falling into them. Work your way around your fencing until all the posts are set.
What is an underground dog fence? An underground dog fence is a system consisting of a radio transmitter, wire that acts as a transmitting antenna and a collar with a receiver that picks up the radio signal from the fence when your dog gets too close. When your dog enters the warning area near the wire the collar beeps warning him to stay back. If he continues to move toward the wire he will receive a static shock or correction. Some systems have progressive corrections so that the closer the dog progresses toward the wire the stronger the static shock he receives. There is some controversy about the humane aspect of delivering a shock to an animal to deter him. Most experts agree however that when an underground dog fence is properly installed and the dog is properly trained to the fence that these systems are very humane and safe. Consider the alternative if your dog runs out into traffic or gets lost. There is some chance of your dog being traumatized by the shock of he is improperly trained and/or the correction levels are too high for your particular dogs size and temperament. Proper training is critical to success with these systems. Yes, it is true that your dog, hopefully, will not like receiving the shock no more than you like touching a door knob and getting a static shock. This is his incentive to avoid the boundary. While the shock is uncomfortable it is not in itself dangerous to the animal. Most systems have automatic shut offs if the animal does not move out of the correction zone to protect him from over correction. Compared to a traditional fence an underground dog fence is fairly easy to install and should take less than a day with most applications. The hardest part of the installation is burying the wire. I offer four methods of burying the wire. The first is to use a straight edge spade shovel and use it to dig down about 3 inches and create a V-shaped trench to lay the wire in. The simply press the sod or dirt back in place. This is the most difficult and time consuming method. The second way is to use a gas powered lawn edger to cut a 3 inch deep trench. Lay the wire in the trench and replace the displaced dirt and press into place. The third method is to rent a trencher with a cable installation attachment. The trencher will cut the trench and lay the wire at the same time. The fourth method is to not bury the wire at all. Instead you can simple lay the wire above ground and use Pet Fence Staples to hold it in place. This method works well for low traffic areas and in grassy areas where the wire will lay deep in the turf. If you have to cross a driveway or sidewalk with the wire you will need to use a masonry blade to cut a groove in the concrete or asphalt and then use caulk to seal the wire into place. There are many factors involved in choosing the right underground dog fence system. Some of these factors are discussed below. Later on Ill make specific recommendations based on these factors. Wireless dog fences are not considered in this discussion.
Any content, trademark’s, or other material that might be found on the Proxifeed website that is not Proxifeed’s property remains the copyright of its respective owner/s. In no way does Proxifeed claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.