Published at Saturday, March 02nd, 2019 - 05:09:07 AM. Privacy Screens. By Raoul Constant.
Building your Own Wood Fence Once you have decided to put a wood fence around your property, here are the basic steps to building one yourself: 1. The first thing you should do is decide on the location of the fence. You can mark the location with some stakes and string. Fences are usually located along your property line, but be sure you are not trespassing on your neighbors property. If so, you will have to relocate your fence sooner or later. 2. The next step is to figure out how high you want your fence to be. Privacy fences are typically about six feet tall whereas picket fences are only about three feet tall. 3. If you havent done it already, be sure to get all the materials you need. You will need items like a posthole digger, hammer, drill, tape measure, circular saw, nails, and the fence posts themselves. A home improvement store can help you find everything to get the job done. 4. Once you have all your supplies, you can begin by setting the end posts, the parts of the fence at the corners. Use a post hole digger to make the holes, ideally about thirty inches deep. You can then set the posts in the hole, make sure the post is level, and then fill in the rest of the hole with dirt or cement. 5. The next step is to place other posts between the end posts. It is recommended to start out placing the posts eight feet apart. You can use a plumbing line made out of string and attached to the posts with nails to make sure that they are all the same height. Use the same technique to set these posts as you did on the end posts. 6. Once you have those posts in place, the next step is to install the horizontal boards along the fence. These 2 x 4 boards are attached with nails, and depending on your preference, they are usually set at the top, center, and bottom of the vertical posts. 7. The next step is to nail the vertical boards all along the fence. Once those are in place, it is a good idea to cover the fence with a high-quality waterproof sealer.
Estimating the Cost of Wood Privacy Fence Installation : What about the premade panels available at the local home improvement store? These premade panels are often made from pressure treated pine with three cross beams that are 1.5x2.25 inches and frequently sag after installation. The cheap fence panels can be suitable for urgent repair purposes but are not recommended for use when installing a new or replacement fence. Wood fence posts must be pressure treated and rated for ground contact. Galvanized steel fence posts offer longer life after a higher initial cost for the post and the post rail brackets that are required. Many homeowners dislike the appearance of the steel posts but this can be overcome by a simple coat of paint or wrapping the steel post in a wood enclosure. The fence rails should be 2x4 lumber from pressure treated pine or cedar wood. The style of privacy fence and the choice of wood used on the pickets will have the biggest impact to the aesthetics of the wood privacy fence installation. The basic privacy fence consists of 3.5 inch wide dog-eared pickets placed on one side of the rails; this style requires 24-25 pickets between each post. Another option is to use the wider 5.5 inch pickets which requires 16-17 pickets between posts that 8 feet apart. After the measurements are made, it is time to choose the materials for your fence.
Any content, trademark’s, or other material that might be found on the Proxifeed website that is not Proxifeed’s property remains the copyright of its respective owner/s. In no way does Proxifeed claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.