Published at Thursday, February 28th, 2019 - 02:03:14 AM. Fence. By Grosvenor Louvet.
Compatibility with other fences and/or barriers If you are planning to use your underground fence in addition to other containment products such as the PetSafe Pawz Away Indoor Barrier, the PetSafe Pawz Away Outdoor Barrier or the PetSafe Indoor Fence, or if you have dogs of different sizes and temperaments, you will need to choose a system that has collar compatibility between them. The PetSafe Deluxe, PetSafe Small Dog, PetSafe Standard and PetSafe Cat collars can be used with any current PetSafe underground fence and the PetSafe Indoor Fence. The Pawz Away and Innotek Ultra collars are compatible with the Innotek Ultra Transmitter as well as the PetSafe Pawz Away Indoor Barrier and the PetSafe Paws Away Outdoor Barrier. All other systems are compatible with their own transmitters only including the PetSafe Wireless Instant Fence which is not part of this review
INSTALLATION- Do we have all our materials? OK lets go. Starting in one corner, dig your first post hole. Dont cheat. A shallow hole will weaken your fence and shorten its life span. A 12 wide hole is acceptable for fence posts. Now continue down one side of the fence line until all the holes are dug. If you are using a pair of hand post hole diggers, your arms are now worn out. If you are using a power post hole auger that you rented, it should make short work of this chore. Place your two end posts in their holes. Plumb them using your 4 level and install two temporary braces on each to hold them plumb. With this done Im going to save your some work here. Pour a bag of the bagged of concrete into each hole DRY. OH, OH. Where is the concrete? You didnt get it? Did you write it down? If you look back I didnt tell you to. OK. Go get the concrete, you need a break anyway. Seriously, it is a good habit to start to write down all the items you need before you go shopping. It saves a lot of time and extra trips. OK now with a dry bag of concrete in each hole; hook up your garden hose without a nozzle. Start placing water on top of the dry concrete and by using your shovel to prod the concrete in an up and down motion and pushing the hose in and out of the concrete it will mix right in the hole. Dont make it too wet. Somewhat soupy is fine but try not to separate the ingredients with too much water. There are several brands of redi-mix bagged concrete available and they will all work this way. You can now start on the holes for the 2nd side while the concrete dries for the first two posts. Perform the same function with the next corner post and the 4th post until all corner posts are set in concrete. Go back to your first two posts. Using your string line, tie it to the first post and run it to the next corner post and tie it off making it as taught as you can between the posts. MAKE SURE THE STRING IS TIGHT AGAINST THE SAME SIDE OF BOTH POSTS. If you use the inside or outside it doesnt matter as long as they are both the same. Now you can install the mid posts without a lot of measuring. By simply pacing the post against the string, you will have them all in the same line. Check carefully that your spacing is correct between posts. The posts may be off center of the holes but thats OK. With all the posts in on one side, pour them in concrete. Try not to leave holes open overnight both for protection against rain and children or animals falling into them. Work your way around your fencing until all the posts are set.
Any content, trademark’s, or other material that might be found on the Proxifeed website that is not Proxifeed’s property remains the copyright of its respective owner/s. In no way does Proxifeed claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.